Ships By 5/01
- What Do You Drive?
- Estimated Horsepower Gain: 15.66 HP @ 4688 RPM
- Not CARB emission certified
- CARB EO Pending: Cannot be shipped to California
- Info about CARB regulations
- Download Dyno Chart (PDF)
- Download installation instructions (PDF)
- Includes K&N filter # RF-1044
- Compatible with filter wrap # RF-1020DK (not included)
We’re sorry. The information you have requested is temporarily unavailable.
K&N 63 Series AirCharger High-Flow Intake Kit Part #63-1561 Customer Reviews
480 Customer Reviews
Reviewed by Melvin R (MARYVILLE, TN) Reviewed for a 2012 Dodge Ram — Tuesday at 8:22 PM
Easy install was surpprised by the appearance looks great under the hood.The sound when you push the gas pedal is unreal.I could not believe the power gain. I would recomend this item for anyone seeking more power from your vehicle.
Reviewed by Mark B (ROWLETT, TX) Reviewed for a 2015 Dodge Ram — Apr 06, 2017 8:42 AM
It sounds great and has definitely improved throttle response. It looks good under the hood and and is definitely well made. My complaint is in the instructions. there are a lot of steps that say things like "as shown" and the picture is less than helpful. or ". . .with the supplied hardware" and its up to you to figure out which of the numerous bolts it is talking about. The biggest issue is the need to use the 90 degree adapter in the crank case vent. (missing any instructions)
Reviewed by Paolo F (katonah, NY) Reviewed for a 2016 Dodge Ram — Apr 03, 2017 6:29 PM
Makes my commute a fun again. Easy to install, included all parts and accessories. Will be installing a K&N Cold Air Intake again on my next vehicle.
Reviewed by Eric M (Cecil, PA) Reviewed for a 2017 Dodge Ram — Feb 23, 2017 1:48 PM
Luckily I have installed a few of these on Ram trucks. This one for sure was the most difficult. Had a little trouble getting the intake hose and intake box to fit properly. A little fidgeting and it finally went in. Directions where a bit iffy. But once in it performed as advertised.
Reviewed by Gar H (Loveland, CO) Reviewed for a 2015 Dodge Ram — Jan 31, 2017 7:13 PM
This was a great upgrade to my Ram 1500. The instructions are not the best. It is hard to determine which bolts go to which part of the intake. I think the pictures could better show some of these parts. This CAI does as advertised. It sounds great above 3,000 rpms and I noticed a little better mileage. I noticed the truck feels a bit more responsive as well. Overall, a great addition!
Reviewed by Kyle A (PHOENIX, AZ) Reviewed for a 2014 Dodge Ram — Jan 26, 2017 9:46 AM
All of the reviews are correct. The 63 series makes your engine growl compared to the stock sound. I haven't had mine installed too long, but my fuel economy has gone down. I attribute that to me wanting to hear the motor and stepping on it every chance I get.
Reviewed by Jarett H (SANDERSVILLE, GA) Reviewed for a 2014 Dodge Ram — Jan 21, 2017 5:48 PM
Very easy to install. This CAI seems to be what my truck has been missing. I've noticed a small power increase and a very noticeable sound increase, my exhaust even has a different sound when I get on it. I wish I would have bought one sooner
Reviewed by Stewart T (Green Valley, AZ) Reviewed for a 2017 Dodge Ram — Jan 10, 2017 9:06 PM
Installation is not too bad but the crankcase breather hose connection to the tube could be better. The bend in the hose has to be too tight, supply a 45 degree elbow or move the connection to make it a better connection. There is also no reason to put the air flow sensor at the back of the tube and have to run the extension cable all the way under it.
- k and n air filter systems
- airaid 401 226
- do you need to tune k&n 63 on a 2011 silverado
- k & n cold air 57-2533
- best ford cold air intake
- air intakes for chevy
- toyota mass air flow upgrade
- mass air flow sensors, 2009 chevy tahoe
- 2005 subaru legacy gt limited weapon air intake
- best cold air intake for dodge charger srt8
- blanket car seat covers
- car floor maps
- truck tent bed